Installation Requirements - AGA R7 100-3 User's Manual & Installation Instructions

12. Installation requirements

Consumer protection
As a responsible manufacturer, we take care to make sure
that our products are designed and constructed to meet the
required safety standards when properly installed and used.
WARNING - ELECTRIC SHOCK HAZARD
n
It is the customers responsibility to contact a qualified
electrical installer to make sure the electrical installation is
adequate and in conformance with the regulations.
Take special care when cutting holes in walls or floor.
Electrical wires may be behind the wall or floor covering and
could cause an electrical shock if you touch them.
Locate any electrical circuits that could be affected by the
installation of this product and disconnect power circuit.
WARNING: THIS APPLIANCE MUST BE EARTHED.
n
DO NOT use an extension lead with this appliance.
The appliance is designed for the voltage stated on the data
plate.
Recommended but not mandatory to fit an individual
Residual Current Device (RCD) to the cooker supply circuit.
Hand this Manual to the User for retention and instruct in the
safe operation of the appliance.
Delivery requirements
• The AGA R7 arrives on 1 pallet
• The AGA R7 with Hotcupboard arrives on 2 pallets.
There must be access to the kitchen to manipulate a foot
print of 39 9/16" (1005mm) x 29 1/8" (740mm). A wooden
template (skate with castor wheels) of dimensions 39 9/16"
(1005mm) x 29 1/8" (740mm) could be used to check if
the AGA R7 fully built appliance is able to fit through the
property grounds and doors into its installation position in
the kitchen. It must also be considered that the height of the
appliance is 37 6/8" (960mm) off pallet and 43 2/8" (1100mm)
on the pallet, so high level obstacles/restrictions must not be
overlooked.
If this skate/template can be manipulated through the
property grounds and doors into position, then the AGA
can be installed as intended with no re-work.
20