Setting Jumpers - JHCTech ALAD-A1001T User Manual

User's Manual
Main board internal diagram-back side:
Figure 2.2 ECM-I714 diagram-back Side

2.2.1 Setting Jumpers

You can configure your ALAD-A1001T to match the needs of your application by setting the jumpers. A
jumper is the simplest kind of electrical switch. It consists of two metal pins and a small metal clip (often
protected by a plastic cover) that slides over the pins to connect them. To —close "a jumper, you connect
the pins with the clip. To —open "a jumper you remove the clip. Sometimes a jumper will have three pins,
labeled 1, 2, and 3. In this case, you would connect either pins 1 and 2 or pins 2 and 3.
Figure 2.3
The jumper settings are schematically depicted in this manual as follows:
7