Introduction; Jumpers And Connectors; Setting Jumpers - JHCTech BRAV-7302 User Manual

2.1 Introduction

The following sections show the internal jumper settings and the external connectors and pin assignments
for applications.

2.2 Jumpers and Connectors

The BRAV-7302 high-performance GPU computer from JHCTECH, consists of a JHC SBC(AXM-I950)
and a sub-card(ECB-147-T001).
The specific combination is as follows：
Model No.
AXM-I950-S001
AXM-I950-T001
GPU
ECB-147-T001

2.2.1 Setting Jumpers

You can configure your BRAV-7302 to match the needs of your application by setting the jumpers. A
jumper is the simplest kind of electrical switch. It consists of two metal pins and a small metal clip (often
protected by a plastic cover) that slides over the pins to connect them. To —close "a jumper, you connect
the pins with the clip". To —open "a jumper you remove the clip". Sometimes a jumper will have three
pins, labeled 1, 2, and 3. In this case, you would connect either pins 1 and 2 or pins 2 and 3.
The jumper settings are schematically depicted in this manual as follows:
BRAV-7302-S001 BRAV-7302-S002
✓

✓

Figure 2.1
9
BRAV-7302-T001
✓ 
 ✓
✓ 
✓ 
User's Manual