Toa NF-2S Setup Manual page 2

If the speaker is too far from
the Sub-Unit:
Normally, the distance between the speaker's mouth and the
Sub-Unit should be between 20 – 50 cm.
If this distance is greater, there are two things that can be done:
[ Change the mounting position of the Sub-Units ]
Even if the Sub-Units cannot be mounted to the partition,
they can be installed in appropriate locations using the
supplied metal plates.
Magnets (2 places)
Metal Plate
(accessory)
To mounting position
[ Use a commercially available stand ]
The Sub-Units can be installed in closer proximity
to the speaker(s) with the use of commercially
available stands or the like.
The instruction manual can be accessed on the TOA DATA Library. Download the manual from QR code* with smartphone or tablet.
For Increased Privacy:
Sound can be prevented from being heard outside the
periphery of the Sub-Units by setting the Base Unit's rear
panel LOW CUT switch to ON.
Muting sound output with an external switch
Sound can be muted as desired by connecting a commercially available
switch or similar device to the external control input terminal of MUTE IN.
For details, please read the instruction manual.
Sub-Unit
For cable arrangement:
Cables can be neatly arranged during installation by using the supplied mounting bases and zip ties.
"QR Code" is registered trademark of DENSO WAVE INCORPORATED in Japan and other countries.
Base Unit (rear)
External control input terminal
Sub-unit
Mounting base
(accessory)
After securing the cables,
cut the zip ties at the base.
Partition
LOW CUT switch
Zip tie
(accessory)
133 - 21 - 00654 - 00