P (32-Bit, Pulse Transmission) - M-system JC-IO User Manual

4.4.8 P (32-bit, Pulse Transmission)

Select S
Select P0 to P255.
Right-click to copy
and paste only
when the setting
values are normal.
Possible to paste
the setting values
copied by "Paste
(+1)" with the
effective register
and device number
increased by 1.
Table 25. P (32-bit, pulse transmission) Setting Parameters
ITEM
Mode
CH name / CH comment
Input
Output
Figure 13. P (32-bit, pulse transmission) Setting Screen
Enable / Disable P register.
Following parameters are configurable when Enable is selected.
Enter the CH name and comment of P register in 32 characters or less.
Connection Select from C0 to C31.
Register Modbus/TCP
SLMP
SWAP Select Enable / Disable.
Modubus/TCP
Eneble: small address is lower, large address is upper
Disable: small address is upper, large address is lower
SLMP
Differs between PLC and device. Set in necessary. Refer to 3.5 SLMP
Pulse range JC-IO accumulates the difference of pulse counter between sampling.
Set the same value as the pulse range set in the remote I/O.
Setting range is as following.
Low limit: 0 to 1,000
High limit: 10,000 to 4,294,967,295
Connection Select from C0 to C31.
Register Modbus/TCP
SLMP
DESCRIPTION
When the protocol of the specified Connection is set to
Modbus/TCP, set the input register. When the unit identifier
is set to variable, set the unit identification number.
When the protocol of the specified Connection is set to
SLMP, set the input device.
The display format for device address can be switched
between octal, decimal, and hexadecimal.
When the protocol of the specified Connection is set to
Modbus/TCP, set the output register. When the unit identifier
is set to variable, set the unit identification number.
When the protocol of the specified Connection is set to
SLMP, set the output device.
The display format for device address can be switched
between octal, decimal, and hexadecimal.
JC-IO USERS MANUAL EM-9044-B 27