Table of Contents
Advertisement
Transition Guide
Ver. 1.00
J208
SW204
SW203
SW201
Figure 5 - SDK0107 Block Diagram
There are two ways to control the power sequence using the combination of the development board and the
module.
The first method is to place SW203 in the OFF position. Apply power to the SDK and the module will turn on
and off with SW201.
The second method is to remove the jumper from J208 and use SW204 to turn the module on. Make sure
SW201 is in the ON position.
EDG0100TG001
Page 10
Rev. 1.00 – 11/03/2005
Advertisement
Table of Contents
