Tar River SRB-870 Instruction Manual page 41

Binding
Fault
*Binding does not
work when bale is
finished
*Binding device
work before
reaching to setting
density
*Twine comes off
from bale
*Twine is not cut
smoothly
Possible cause
*Binding is not set in correct initial
position
*Insufficient lubrication
*Wrong adjustment of tensioned
spring
*Twine is coming off from twine
pulley
*Twine is tangled or caught
*Lower density in bale left side
*Binding arm does not rise up after
coming off latch
*Twine tip does not come in chanber
*Binding is not set in correct initial
position
*Longer leading twine length
because of dull blade
*Fewer twine binding number
*Twine tension is too loose
Remedy
*Adjustment in according with"1-4-5
Method of twine treading"
*Lubrication
*Adjustment in accordance with"5-2-3
Adjustment of twine tension"
*Adjustment in accordance with"1-4-4
Method of twine threading"
*Remove tangle and catch of twine
*Supply of larger quantity of material to
left side of the machine.
*Lubrication and adjustment of falling
speed by double nuts.
*Adjust falling down speed of twine
arm not to be ahead of twine falling.
*Remove obstruction and let twine tip
into chamber.
Wipe off part of machine.
*Adjustment in accordance with"1-2-4
Method of twine threading"
*Replacement of blade and adjustment
of leading twine length in accordance
with"1-4-4 Method of twine threading"
*Adjustment in accordance with" 3-2-2
Adjustment of twine binding number"
*Tighten nylon nuts of twine tension
plate one or two turns.
41