Table of Contents
Advertisement
Caution
•
Apply original replacement blade of the machine.
9-
10- Adjustment of the bale density link.
a.
Adjust the clearance between stopper and collar on gate by bolt.
L
= 1-2 mm
is proper.
1
b. Remove the from fork end on from lower end of release rod and them pull the release rod to
lower.
Adjust the dimension between lower side of fork end slot and the hole of stopper as mentioned
below in above situation.
L
= 2 mm is proper.
2
c. Adjust the dimension between lath and cut out of control bar as below.
L
= 8 mm
is proper
3
Adjust this dimension to
If bale weight is too heavy (Move than 25kg) because of too much moisture content.
11- Adjustment of Pick-up Suspension
Proper suspension springs length on both sides of pick-up is L=48 mm.
Adjust spring length per field condition if the pick-up does not follow well the field unevenness.
L
=6 mm
3
35
Advertisement
Table of Contents
