Table of Contents
Advertisement
1) Inspection of the tractor parts
Inspect the tractor parts in accordance with operation manual of the tractor.
Inspection of connecting parts
2)
I.
Inspection of 3P connecting parts
a. Make sure that locking pin is inserted into the hole of low link pin.
b. Make sure that locking pin is inserted into a hole of top link pin.
c. Make sure that check chains of the tractor are stretched firmly.
d. If any problem is found in connection, remedy the problem according to the instruction "1-4
Attachment to tractor"
II.
Inspection of PTO shaft
a. Make sure that cramp pins stay in the groove of PTO shaft and PIC shaft.
b. Make sure that chain of safety cover has excess slackness.
c. Check the damage on safety cover of PTO shaft.
d. If any problem is found on PTO shaft, remedy the problem according to the instruction "1-5
Attachment of PTO shaft"
3) Inspection of the machine
a. Check looseness of nuts and bolts.
Tighten loosen nuts and bolts firmly.
b. Check if the shear bolt is sheared or not.
If it is sheared replace to new one referring sufficient. To the parts list.
Beforehand, prepare for replacement shear bolts.
c. Check if roller chain is properly stretched.
Adjust it in accordance with the instruction "5-2-1 Adjustment of roller chain stretch."
d. Check the length of pick up tension if the length is improper, adjust the length in accordance
with the instruction of "5-2-2 Pick-up V-belt tension adjustment."
e. Check the length of twine tensioner.
If the length is improper, adjust it in accordance with the instruction "5-2-3 Adjustment of
twine tensioner."
f.
Check the twine cutting blade for sharpness. Adjust the blade if necessary according to this
manual.
g. Check if twine is enough, twine is threaded properly and binding arm is in proper position.
If any problem is found, solve it in accordance with the instruction "1-4-4 Method of twine
treading."
h. Check damage of tine and rotor flush.
If it is damaged, replace it to a new one by referring to parts list.
i.
Check stuck hay or straw in the machine.
Remove stuck crop from the machine.
j.
Check application of oil and grease. If it is not applied properly lubricated in accordance with
the instruction "2-3 Lubrication spots table."
k. Check if tire air pressure is sufficient. If it is Insufficient, apply air until the pressure becomes
195kPa (2.0Kg/m
4) Inspection with tractor engine running
Inspection Before Operation
2
).
17
Advertisement
Table of Contents
