Fire-Lite Alarms MS-5012 Installation, Operation, And Programming Manual page 47

End Programming
w
Exit Programming Mode by pressing , followed by the 4-digit code
corresponding to an alternate mode of operation, then hit enter/store.
During Program Mode, if no key is pressed within 10 minutes, the panel
will revert to normal mode.
Programming the Real-Time Clock
Entering an address greater than 243 will cause a display of the current
time. On initial power up, the clock will start running from the factory
setting of 00:00 (military time). The far left digit will be flashing,
indicating that this will be the first digit to be programmed. Simply
enter the correct digits of the current time, followed by enter/store.
47
15465 Rev F 5/2/97 P/N 15465:F
Technical Manuals Online! - http://www.tech-man.com
firealarmresources.com