PowerBox Systems PBR-12X Instruction Manual page 5

Spektrum SRXL 2
Use the optional adapter lead set (#9192) to connect one or two SPM4651T satel-
lites to the PBR-12X. If only one receiver is connected, this must be connected to
RX1 in order to transfer telemetry data. The battery data are now displayed at the
transmitter under PowerBox Sensor. The receiver data can be seen in RX data at
the transmitter in the usual way.
By default the PBR-12X operates in DX18 compatibility mode.
3.Settings
The PBR-12X requires only a few adjustments. You will find all the settings either
in the transmitter menu (CORE, ATOM, Jeti), in PC-Terminal or in Mobile-Terminal.
To reach the menu with a PowerBox CORE/ATOM transmitter, set up any telemetry
widget for the PBR-12X in the usual way-. You will then see the Menu button in the
widget.
With a Jeti system you will find the Jetibox point under Auxiliary Functions. Select
this point, and press MX at far right. If you now press at the bottom, you will find
yourself in the PBR-12X menu again.
a) Frame rate
This function is used to adjust the signal repeat rate to match the servo. For older
analogue servos we recommend the 18ms setting; for more recent digital servos
you can select 12ms. The default setting is 16ms.
www.powerbox-systems.com 5