PowerBox Systems PBR-12X Instruction Manual page 4

If you wish to enter the fail-safe positions with a Futaba or Spektrum system, you
must first bind RX1 to the transmitter; you can then start the Terminal-App on your
PC. The PowerBox Terminal-App is available for downloading from our website.
PowerBox and Jeti pilots have the facility to carry out all adjustments from the
transmitter.
2. Connecting to the radio control system
PowerBox CORE
Connect the P²BUS output of one or two receivers to the sockets marked RX1 and
RX2. If you are only using one receiver, this must be connected to RX1 in order to
transfer telemetry data.
Jeti EX-BUS
Set one output of the receivers you intend to use to EX-BUS. The frame rate should
be set to 10ms, and the Failsafe-function must be switched "OFF". If only one recei-
ver is connected, this must be connected to RX1 in order to transfer telemetry data.
Futaba S.BUS2
Connect the S.BUS2 output of one or two receivers to the sockets marked RX1
and RX2. If only one receiver is connected, this must be connected to RX1 in order
to transfer telemetry data. At the transmitter this receiver must also be set as the
Telemetry receiver.
To receive telemetry data you must carry out a "Load New" process at the trans-
mitter in the Telemetry Sensor menu; this action completely erases the sensor list.
Now select Slot 1 in the sensor list, and choose "Cur.F1678". The telemetry data
now appear in Slot 1 onwards.
4 PowerBox-Systems − World Leaders in RC Power Supply Systems