HIKVISION DS-2CE12KF3T-PIRXO User Manual page 15

automatically turn on the white light and set it to
1-level brightness.
3.5 FUNCTIONS
In the FUNCTIONS submenu, you can set the motion
detection and the privacy mask of the camera.
3.5.1 ALARM SETTINGS
ALARM MODE
In the ALARM mode, you can select the ALARM MODE
as SOLID, or FLASHING.
SOLID

Select the ALARM MODE as SOLID. In this way, the
white light source turns on, when the PIR module
received the alarm signal.
In TIME SETTING, you can set the time as 5 s, 10 s, 15 s,
30 s, or 60 s, which means that the solid mode stays for
the set time when the camera receives one alarm
signal.
Note:
The solid mode stays for another set time when the
second alarm signal is received, and the rest can be
done in the same way.
FLASHING

Select the ALARM MODE as FLASHING. In this way, the
white light source flashes when the PIR module receives
the alarm signal.
PIR LEVEL
Adjust the sensitivity of the PIR module, and the higher
the value is, the more sensitive the PIR module is.
PIR DET MODE
OUTDOOR and INDOOR are selectable for PIR DET
MODE switch.
ALARM SOURCE
You can set ALARM SOURCE as SIREN, ATTENTION,
WARNING and USER-DEFINED.
Note:
USER-DEFINED option appear on the interface only
after the user uploads the custom voice.
ALARM TIMES
You can set ALARM TIMES from 1 to 5, and the default
number is 3.
SPEAKER
You can set SPEAKER to AUTO, BUILT-IN or EXTERNAL.
AUTO:
The built-in speaker will play the audio source if the
Lineout cable is not connected to any device.
The external speaker will play the audio source if the
Lineout cable is connected to an external device.
BUILT-IN: The built-in speaker will play the audio
source.
EXTERNAL: The external speaker will play the audio
source.
VOLUME
You can select VOLUME as LOW, MEDIUM or HIGH.
3.5.2 MOTION DETECTION
In the user-defined motion detection observation area,
the moving object can be detected and the alarm will