HIKVISION DS-2CE12KF3T-PIRXO User Manual page 10

1). Rotate the enclosure to adjust the pan position
[0° to 360°].
2). Move the main body up and down to adjust the
tilt position [0° to 75°].
3). Rotate the main body to adjust the rotation
position [0° to 360°].
2.2.2 Ceiling Mounting with Junction Box
Before you start:
You need to purchase a junction box in advance.

Ceiling mounting with a junction box is similar to

ceiling mounting with an inclined ceiling mount.
Following steps take a junction box as an example.
Steps:
1. Loosen screws to take apart the junction box.
2. Paste the drill template for junction box to the
installation location.
3. (Optional) For cement ceiling, drill the screw holes
with a 5.5 mm drill and insert the supplied wall
plugs.
4. (Optional) Drill the cable hole, when the cables are
routed through the ceiling.
5. Secure the junction box body on the ceiling with
three or four PA4 × 25 screws according to the
actual object.
6. Fix the camera to the junction box.
 For DS-1280ZJ-S/DS-1281ZJ-S:
PM4
Installation Plate
Figure 2-8 Fix the Camera to the Junction Box
 For DS-1280ZJ-TR13
PM4 × 25
Installation Plate
Figure 2-9 Fix the Camera to the Junction Box
7. Route the cables through the bottom cable hole or
the side cable hole of the junction box.
8. Refer to Step 5 of Section 2.2.1 to adjust the angle
and finish the installation.
2.2.3 Wall Mounting
Before you start:
You need to purchase a wall mount in advance.
Steps:
Figure 2-7 3-Axis Adjustment
PM4 × 25
PM4