Table of Contents
Advertisement
H7BR
Teaching Mode
Changing to the Teaching Mode
1. Press the TEACH key to switch from run mode to
teaching mode.
2. When prescale teaching is not used, press MODE key to
continue teaching for the set value 1 (see next page).
Teaching for the Prescale Value
1. Set value can be set in the teaching mode.
• 0.000 is displayed on the setting position.
2. Sequence when changing a digit using the increment keys
(1 to 6).
• Displays 0 when pressing one key from the increment
keys.
3. Input the count signal of the converted value from external
sensor.
• The display to the right indicates that the controlled
object has been moved 10 cm, causing 50 counts to
be input from an external sensor.
4. Press TEACH key to set the set value.
(Set value 0.2 = 10cm/50).
• If the value input in example 3 is negative, the prescale
value will be calculated using the absolute value.
• The prescale value is rounded off to four significant
digits.
• Prescale value is displayed by teaching while pressing the
TEACH key.
20
H7BR
Advertisement
Table of Contents
