Table of Contents
Advertisement
MERLIN STEALTH
Example: To change the Number of Events allowed to
8, enter 0 3 7 #
ALARM RE-ARM TIME
The alarm annunciation process may be repeated after a re-arm period. The re-arm time for the
system can be changed by pressing the 2 key, followed by the 0 key. Select the desired re-arm
time from the table and press the corresponding number from 0 to 9 followed by the # key. The
keypad will beep three times to indicate that the new setting was accepted. Do not alter without
understanding the ramifications! On turning the system OFF and On again manually all alarm
timers and counters are reset. Please see attached ALARM SETTING EXAMPLES.
Example: To change the re-arm time to 4 days, enter 2 0 6 #
GATE 1 DELAY TIME
The time delay for the gate to stay open before the alarm is activated, can be changed by
pressing the 0 key, followed by the 4 key. Select the desired time delay from the table and
press the corresponding number from 0 to 9 followed by the # key. The keypad will beep twice
to indicate that the new setting was accepted.
Example: To change the Gate Delay Time to 1 Minute,
enter 0 4 5 #
Installer Options
0
1 Event
1
2 Events
2
3 Events
3
4 Events
4
5 Events
5
6 Events
6
7 Events
7
8 Events
8
9 Events
9
16 Events
0
20 Sec
1
6 Hr
2
12 Hr
3
24 Hr
4
2 Days
5
3 Days
6
4 Days
7
5 Days
8
6 Days
9
7.7 Days
0
2 Sec
1
5 Sec
2
10 Sec
3
30 Sec
4
45 Sec
5
1 Min
6
2 Min
7
3 Min
8
4 Min
9
4 Min 30 Sec
6
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the MERLIN STEALTH and is the answer not in the manual?
Questions and answers
the gate 1 and gate 2 lights arent working Why
Gate 1 and Gate 2 lights may not be working on the Nemtek MERLIN STEALTH if there is an issue with the Master energizer, as Gates 1 and 2 are associated with the Master. Possible reasons include:
1. A tamper or service condition on the Master energizer.
2. Power supply issues to the energizer or gate circuits.
3. Faulty wiring or connections to the lights.
4. Incorrect keypad use—Master keypad should be used only on the Master unit.
Check the Master energizer status and connections for faults or tamper indicators.
This answer is automatically generated