Table of Contents
Advertisement
MERLIN STEALTH
SIREN-ON TIME
The time that the siren will be on for, can be changed by pressing
the 0 key, followed by the 1 key.
corresponding number from 0 to 9 followed by
the # key. The keypad will beep three times to indicate that the new setting
was accepted.
Example: To change the Siren-On Time to 4 minutes,
enter 0 1 8 #
ALARM-OFF TIME
The time for all alarm events to be ignored after the Siren-On Time has elapsed, can be changed
by pressing the 0 key followed by the 2 key. Select the desired time from the table and press
the corresponding number from 0 to 9 followed by the # key. The keypad will beep three times
to indicate that the new setting was accepted.
Example: To change the Siren-Off Time to 2 minutes,
enter 0 2 6 #
NUMBER OF ALARM EVENTS BEFORE RE-
ARM
The number of alarm events that are allowed before the RE-ARM timer becomes active. This can
be changed by pressing the 0 key, followed by the 3 key. Select the desired number of times
from the table and press the corresponding number from 0 to 9 followed by the # key. The
keypad will beep three times to indicate that the new setting was accepted.
Select the desired time from the table and press the
Installer Options
0
2 Sec
1
5 Sec
2
10 Sec
3
30 Sec
4
45 Sec
5
1 Min
6
2 Min
7
3 Min
8
4 Min
9
4 min 30 sec
0
2 Sec
1
5 Sec
2
10 Sec
3
30 Sec
4
45 Sec
5
1 Min
6
2 Min
7
3 Min
8
4 Min
9
4 min 30 sec
5
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the MERLIN STEALTH and is the answer not in the manual?
Questions and answers
the gate 1 and gate 2 lights arent working Why
Gate 1 and Gate 2 lights may not be working on the Nemtek MERLIN STEALTH if there is an issue with the Master energizer, as Gates 1 and 2 are associated with the Master. Possible reasons include:
1. A tamper or service condition on the Master energizer.
2. Power supply issues to the energizer or gate circuits.
3. Faulty wiring or connections to the lights.
4. Incorrect keypad use—Master keypad should be used only on the Master unit.
Check the Master energizer status and connections for faults or tamper indicators.
This answer is automatically generated