Port 1 Compression Status - Paradyne FrameSaver 9620 User Manual

Displaying System Information

Port 1 Compression Status

4-16
Compression statuses appear when Port-1 Compression Status is selected from
the Status menu. Data compression must be enabled for these statuses to
appear.
Follow this menu sequence:
Main Menu Status
Field Status
Port Throughput 0 to 256
(Kbps)
DLCI 16 through 1007
Rx Throughput (Kbps) 0 to 256
and
Tx Throughput (Kbps)
Connection Status Connected
Disconnected
Disabled
Rx Compression 0.1:1 to 25:1,
1
Ratio and in increments of 0.1
Tx Compression
1
Ratio
No Data
1
Only displayed when the DLCI has Compression enabled.
August 1997
Port-1 Compression Status
What It Indicates
Amount of data compression
throughput for the previous
5 second measurement period.
Identifies the LMI-reported DLCI
numbers assigned to Port 1 – the
identifying number assigned to the
path between two frame relay
access unit's ports.
DLCIs selected may be
compressed or non-compressed.
Pressing the Spacebar displays the
next configured DLCI.
DLCI statuses are listed in
ascending order ( i.e., lowest
number first ).
Amount of data compression
throughput received/transmitted for
the previous 5 second
measurement period for the
specified DLCI.
Specified compression DLCI's
connection status with the far-end
access unit.
Compression is disabled for this
DLCI.
Ratio at which data received/
transmitted is being compressed for
the specified DLCI.
Compression ratios do not appear if
Connection Status is Disconnected
or the frame relay Link Status
configuration option is disabled.
No data has yet been received/
transmitted on this DLCI.
1
1
9621-A2-GB20-30