Paradyne FrameSaver 9620 User Manual page 31

Displaying System Information
4-6
Message What It Indicates
DBM Download A download attempt was
Required interrupted and failed to
complete.
The NAM software and
DBM software are
incompatible.
Only appears when a dial
backup module (DBM) is
installed.
Device Fail yyyyyyyy An internal error has been
detected by the operating
software.
DLCI nnnn Down, Alarm has been generated
1
interface because the specified Data
Link Connection Identifier is
down for the Network,
Port 1, Port 2, or BRI-B1
(B channel) interface.
1
nnnn indicates a DLCI number of 16 through 1007; interface is the Network, Port 1,
Port 2, or the basic rate interface B channel.
August 1997
What To Do
Download function is controlled
and for service personnel only.
Call your service
representative.
1. Provide the displayed 8-digit
failure code ( yyyyyyyy ) to your
service representative.
2. Reset the access unit to clear
the condition and message.
If Network interface:
Contact network provider.
If a port interface:
Verify that all connections to
frame relay equipment are
secure and operational.
If BRI-B1 interface:
Verify that the RJ45 backup
cable (ISDN-U) is properly
seated in the physical
interface (BKP).
Wait and see if the DLCI's link
is active on the primary
destination link.
– If it is, no action is required.
– If not, contact network
provider.
No action is needed if
communicating directly with
another access unit. The other
unit has chosen to revert back
to the primary destination link.
9621-A2-GB20-30