Paradyne FrameSaver 9620 User Manual page 32

9621-A2-GB20-30
Message What It Indicates
Excessive BPVs An excessive number of
2
hhh:mm:ss bipolar violations has been
detected on the DDS
network interface, followed
by the period of time that
the condition has existed.
Caused when at least one
invalid BPV has occurred
every 20 ms for 2 seconds.
ISDN Active An ISDN call is active.
Only appears when a dial
backup module (DBM) is
installed.
ISDN Network Failed An ISDN network failure
(Active/ Idle) was detected when:
Only appears when a dial
backup module (DBM) is
installed.
LMI Down, interface The Local Management
Interface is down for the
Network, Port-1, Port-2,
BRI-B1, or BRI-B2.
LMI for a BRI interface only
applies when the B channel
is configured as the
originating device/interface
(Originate or Answer
configuration option set to
Originate).
2
hhh:mm:ss indicates the number of hours (maximum 255), minutes (maximum 59),
and seconds (maximum 59). When the time has been exceeded, 255:59:59+
appears.
August 1997
Active – Backup call was
in progress.
Idle – DBM was in Idle
mode.
Displaying System Information
What To Do
Verify that the network cable is
securely attached at both ends.
No action needed.
Contact network provider if
problem persists.
See if the DLCI's link is active
on the alternate destination
link.
– If it is, no action is required.
– If not, contact network
provider.
Contact network provider if
problem persists.
4-7