Dbm Interface Status - Paradyne FrameSaver 9620 User Manual

Displaying System Information

DBM Interface Status

4-18
ISDN BRI DBM statuses appear when DBM Interface Status is selected from the
Status menu. These statuses only appear when a DBM is installed and the ISDN
BRI DBM's BRI-B1 configuration option is enabled.
Follow this menu sequence:
Main Menu Status
Field Status
Line Status Active
Inactive
Inv SPID
Inv Local Number
Inv Call ID
Operating Mode Disabled
Idle
Testing
Active
1
If Operating Mode is Disable, no other fields will appear.
2
If Operating Mode is Idle, Active Call Profile and Negotiated Rate will not appear.
August 1997
DBM Interface Status
What It Indicates
Status of the ISDN line.
Active – The ISDN line is active
and no error conditions exist.
Inactive – The ISDN line is
disconnected or an ISDN
network alarm condition exists.
Inv SPID – The switch has
rejected one of the configured
SPIDs.
Inv Local Number – The phone
number configured for the
B channel is an invalid local
number.
Inv Call ID – The incoming call
was rejected because the Calling
ID did not match the number in
any of the enabled ISDN Call
Profiles. The rejected Calling ID
appears in the BRI-B1 Remote
Call ID field.
1
Status of the ISDN BRI DBM.
2
Disabled – ISDN B channel is
disabled.
Idle – No calls are currently
active on the DBM interface, and
no tests are being run.
Testing – A network-initiated test
is running on the DBM interface.
Active – At least one backup call
is active on the DBM interface.
9621-A2-GB20-30