Paradyne FrameSaver 9620 User Manual page 33

Displaying System Information
4-8
Message What It Indicates
Low Compr Ratio, The compression ratio for
1
DLCI nnnn the specified DLCI on
Port 1 has fallen below the
threshold that had been
configured.
Only appears when
compression has been
enabled.
NAM Download Failed A download attempt was
interrupted and failed to
complete; an invalid control
file was downloaded to the
DBM.
Network Com Link The communication link for
Down the COM port is down, and
the COM port is configured
for Net Link.
3
No Signal hhh:mm:ss A NS condition has been
detected on the DDS
network interface, followed
by the period of time that
the condition has existed.
Out of Frame An OOF condition has been
3
hhh:mm:ss detected on the DDS
network interface, followed
by the period of time that
the condition has existed.
Out of Service An OOS condition has
3
hhh:mm:ss
been detected on the DDS
network interface, followed
by the period of time that
the condition has existed.
1
nnnn indicates a DLCI number of 16 through 1007; interface is the Network, Port 1,
Port 2, or the basic rate interface B channel.
3
hhh:mm:ss indicates the number of hours (maximum 255), minutes (maximum 59),
and seconds (maximum 59). When the time has been exceeded, 255:59:59+
appears.
August 1997
What To Do
If not a temporary condition:
Raise the Compression Ratio
Threshold from the ( Path:
main/configuration/edit/
user/com).
Disable the Compression
Ratio Alarm.
Check the type of data being
compressed for its
compressibility.
Disable compression if data is
already being compressed.
Download function is controlled
by and for service personnel
only.
Call your service
representative.
Check the router connected to
the COM port.
1. Check for a cross-pair
condition.
2. Verify that the network cable is
securely attached at both
ends.
3. Contact network provider.
Contact network provider.
1. Check for a cross-pair
condition.
2. Verify that the network cable is
securely attached at both
ends.
3. Contact network provider.
9621-A2-GB20-30