Changing The Class-Of-Service State In Multiple Station Groups; Changing The Class-Of-Service State In An Individual Station Group; Terminating Class-Of-Service Interrogation - Siemens HiPath 4000 Operating Instructions Manual

Attendant console ac4

Hide thumbs Also See for HiPath 4000:

Table of Contents

Class-of-service changeover for station groups

Step by Step

ENTER

COS

PROG

Changing the class-of-service state in multiple

station groups

You activated the station groups with class-of-service changeover.

To change groups individually: press group number 1 to 8. To change

all groups together: press 0.

Press Memory input. The ON/OFF or OFF/ON state change is stored.

The message STORED appears in line 12. NOT POSSIBLE appears if

an unavailable group was selected.

Changing the class-of-service state in an indi-

vidual station group

In the case of a single station group, you can change the class of ser-

vice with the Class-of-service changeover key.

Prerequisite: the terminal is idle or in call state.

Press Class-of-service changeover.

The class of service is changed (ON/OFF).

If 5 seconds have elapsed since an entry was performed, the

Program menu is displayed.

You can retrieve the list by pressing Class-of-service changeo-

ver or terminate the interrogation.

Press Program menu or answer a new call.

The memory inquiry is terminated.

Table of Contents