Programming Firmware Application - ST Nucleo STM32F302R8 User Manual

UM1784
4.1

Programming firmware application

To program the STM32 Nucleo board with the demonstration application please proceed as
follows:
1. Install the preferred Integrated Development Environment (IDE)
2. Install the ST-LINK/V2.1 driver available on ST website.
There are two ways of programming the STM32 Nucleo board:
•
Method1:
Upload the STM32CubeF3_Demo_Nucleo.hex from the firmware package available
under Projects\STM32F302R8-Nucleo\Demonstrations\Binary,
Projects\STM32F303RE-
Nucleo\Demonstrations\Adafruit_LCD_1_8_SD_Joystick\Binary or
Projects\STM32F334R8-Nucleo\Demonstrations\Binary using your preferred in-system
programming tool.
•
Method2:
Choose one of two supported tool chains (IAR
–
–
–
–
–
–
The demonstration software as well as other software examples that allow you to discover
the STM32 microcontroller features are available on ST website at
www.st.com/stm32nucleo.
Open one of the application folders:
Projects\STM32F302R8-Nucleo\Demonstrations\Binary, or
Projects\STM32F303RE-
Nucleo\Demonstrations\Adafruit_LCD_1_8_SD_Joystick\Binary, or
Projects\STM32F334R8-Nucleo\Demonstrations\Binary
Chose the desired IDE project (EWARM for IAR, MDK-ARM for Keil)
Double click on the project file (for example Project.eww for EWARM)
Rebuild all files: Go to Project and select Rebuild all
Load the project image: Go to Project and select Debug
Run the program: Go to Debug and select Go.
DocID026524 Rev 2
Demo functional description
® ®
/ Keil ) and follow the steps below:
15/18
17