Figure 8 Power Switch Location - Nokia IP561 Installation Manual

Figure 8 Power Switch Location

Caution
To avoid potential service interruptions from momentary facility power interruptions and
potential power spikes that might damage your equipment, Nokia strongly recommends
that you use an uninterruptible power supply (UPS) with surge protection with your
IP561.
To connect the power supply
1. Connect the power cord securely into the power cord receptacle on the power supply.
2. Plug the other end of the power cord into a three wire grounded power strip or wall outlet.
3. Toggle the 1/O power switch to the 1 position to provide power to the IP561.
The fan unit on the power supply turns on when you press the power switch. Verify that the
power supply fans are running after you press the switch.
Note
The
[85 to 264]) and configures itself appropriately.
4. Check the power LED (the Nokia logo) on the front panel of the appliance to ensure that the
power supply is operating correctly.
The power LED should be illuminated. For more information about the system status LEDs, see
"System Status LEDs"
If the fans are not running, or if the power LED is not illuminated, make sure:
The power cord is properly connected.
The power supply switch is on.
The chassis tray assembly is pushed all the way in from the front of the appliance.
That power is turned on to the power strip or wall receptacle into which you plugged the
appliance.
Nokia IP561 Security Platform Installation Guide
Power supply
Power cord receptacle
IP561
power supply automatically detects the input voltage (115 VAC or 220 VAC
on page 23.
Connecting Power and Turning the Power On
Power switch
00353
37