Installing Nics; Before You Begin - Nokia IP561 Installation Manual

Installing and Replacing Network Interface Cards

Installing NICs

Use these instructions to install a NIC in the IP561. Some steps are not applicable to all
procedures. The instructions point out steps appropriate to each procedure.

Before You Begin

To install a Nokia NIC, you need the following:
A Phillips-head screwdriver
Physical access to the appliance
Access to the appliance by using Nokia Network Voyager or the CLI
A suitable, grounded work surface
A field replaceable unit kit, including the NIC
Note
You do not need to manually disconnect power for this procedure. If the power supply switch
at the rear of the appliance is difficult to reach, you can safely disconnect power when you
remove the chassis tray assembly from the front of the appliance. Any servicing of the
appliance, however, should be completed with the chassis tray assembly fully removed from
the appliance.
To install a network interface card
1. Use Nokia Network Voyager or command-line interface (CLI) to perform an orderly
shutdown of the IP561 appliance.
For information about how to access Network Voyager and the related reference materials,
see
2. Turn off the power to the IP561 appliance.
3. Loosen the two front panel retaining screws.
44
"Using Nokia Network Voyager"
SLOT 1
on page 40.
SLOT 2
Chassis tray assembly retaining
screws
Nokia IP561 Security Platform Installation Guide
SLOT 3 SLOT 4
1
2
3
4
00354gen