Nokia IP561 Installation Manual page 21

Note
The cable described in this section is a rollover cable, which is required for IP561 console
and auxiliary port connections. You cannot use standard Ethernet cables for IP561 console
and auxiliary connections.
To connect the cable, push the connector into the receptacle, as you would with other similar
cables. To disconnect the cable, push the cable toward the appliance, pull back on the boot to
release the latch, and pull the connector out of the receptacle.
You can connect the other end of the cable to a DB-9 console connection (using the appliance
console port and the DB-9 female adaptor) or to a DB-25 modem connection (using the
appliance auxiliary port and the DB-25 male adaptor). The DB-9 adapter is provided with the
cable. The DB-25 adaptor is provided with Nokia modem cable kits for the IP561.
Nokia IP561 Security Platform Installation Guide
To connect the cable
To disconnect the cable
DB-9 female adapter
Nokia IP561 Security Platform Overview
1 + 2 =
Pull boot
2
Push cable
1
DB-25 male adapter
00548a
00552
21