Disassembly Instructions - Mitsubishi Electric MCF-C13UV-E1 Service Manual

12

DISASSEMBLY INSTRUCTIONS

<"Terminal with lock mechanism" Detaching points>
In the case of terminal with lock mechanism, detach the terminal as shown below.
(1)
1Slide the sleeve.
2Pull the terminal while
12-1. MCF-C13UV -
INDOOR UNIT
OPERATING PROCEDURE
1. Removing the electronic control P. C . board.
(1) Pull out the upper part of the grille.
( Photo 1 )
(2) Remove the screws of the grille.
(3) Remove screws of terminal block cover. (Photo 2)
Remove the terminal block cover and remove the terminal
block.
(4) Remove the screws of the electrical box cover.
(5) Pull out the electronic control P.C. board. (Photo 3)
Photo 3
Electronic control P.C. board
2. Removing the indoor fan motor
(1) Remove the grille. ( Refer to 1(1) (2) )
(2) Remove the screws of pipe support assembly.
(3) Remove the fan casing.(upper).
(4) Disconnect the connector of the indoor fan motor.
(5) Disconnect the ground wire of the fan motor.
(6) Remove the screws of the motor band and remove the
catch.
(7) Take out the sirocco fan and the indoor fan motor.
(2)
pushing the locking
lever.
MCF-C18UV -
E1
1Hold the sleeve, and
pull out the terminal
slowly.
MCF-C24UV -
E1 E1
Photo 1
Photo 2
Electrical box
Photo 4
Fan casing
(upper)
Indoor fan motor
37
PHOTOS
Screws
Grille
Terminal block
Motor band
Fan
casing(upper)
Screws