Disassembly Instructions - Mitsubishi Electric NTXMMX A AA Series Service Manual

10

DISASSEMBLY INSTRUCTIONS

<Detaching method of the terminal with locking mechanism>
The terminal which has the locking mechanism can be detached as shown below.
There are 2 types of the terminal with locking mechanism.
The terminal without locking mechanism can be detached by pulling it out.
Check the shape of the terminal before detaching.
(1) Slide the sleeve and check if there is a locking lever or not.
Sleeve
Locking lever
NTXUKS09A112AA NTXUKS12A112AA NTXUKS18A112AA
NTXUKS09A112BA NTXUKS12A112BA NTXUKS18A112BA
NOTE: Turn OFF the power supply before disassembly.
OPERATING PROCEDURE
1. Removing the intake grille
(1) Slide the tabs (2 places) of intake grille in the direction
of the arrow (Figure 1).
(2) Hold the intake grille and pull it down to open (Figure 2).
(3) Slide the grille shafts (1 each on the left and right
sides) off the intake grille and remove the intake grille
(Figure 3).
(4) Remove the safety strings of intake grille from the
hooks (Figure 4).
Figure 1
Tab
Figure 3
Shaft
OBHT802B
(2) The terminal with this connector shown below
Slide the sleeve.
Pull the terminal while
pushing the locking lever.
Photo 1
Remote control
receiving section
Electrical
parts
Safety string
Figure 2
Figure 4
37
has the locking mechanism.
Hold the sleeve, and
pull out the terminal slowly.
Connector
: Indicates the visible parts in the photos/figures.
: Indicates the invisible parts in the photos/figures.
PHOTOS/FIGURES
Places for installing the air cleaning filters [(Anti-
Allergy Enzyme filters (option)]
[Install to air filters.(Air purifying filter)]
Places for installing
the air filter(Air purifying filter)
Hook
Safety string
Horizontal vane
Intake grille
Safety string