Disassembly Instructions - Mitsubishi Electric SUZ-SWM30VA TH Series Service Manual

DISASSEMBLY INSTRUCTIONS

11
<Detaching method of the terminal with locking mechanism>
The terminal which has the locking mechanism can be detached as shown below.
There are 2 types of the terminal with locking mechanism.
The terminal without locking mechanism can be detached by pulling it out.
Check the shape of the terminal before detaching.
(1) Slide the sleeve and check if there is a locking lever or not.
Sleeve
Locking lever
11-1. SUZ-SWM30VA
SUZ-SHWM40VAH
NOTE: Turn OFF the power supply before disassembly.
OPERATING PROCEDURE
1. Removing the cabinet
(1) Remove the screws of the service panel.
(2) Remove the screws of the top panel.
(3) Remove the screw of the valve cover.
(4) Remove the service panel.
(5) Remove the top panel.
(6) Remove the valve cover.
(7) Disconnect the power supply cord and indoor/outdoor con-
necting wire.
(8) Remove the screws of the cabinet.
(9) Remove the cabinet.
(10) Remove the screws of the back panel.
(11) Remove the back panel.
Photo 2
Screws of the top panel
Screws of
the cabinet
Screws of
the service
panel
Screw of
the valve cover
OCH796A
Slide the sleeve.
Pull the terminal while
pushing the locking
lever.
SUZ-SHWM30VAH
SUZ-SHWM40VAH-SC
Screw of the back panel
Screws of
the cabinet
Screws of
the back panel
(2) The terminal with this connector shown below
has the locking mechanism.
Hold the sleeve, and
pull out the terminal
slowly.
Connector
SUZ-SWM40VA2
SUZ-SWM60VA2
: Indicates the visible parts in the photos/figures.
: Indicates the invisible parts in the photos/figures.
PHOTOS/FIGURES
Photo 1
Screws of the top panel
Screws of
the cabinet
40
SUZ-SWM40VA2-SC
SUZ-SWM60VA2-SC
Screws of
the cabinet