Mitsubishi Electric MCF-C13UV-E1 Service Manual page 42

OPERATING PROCEDURE
3. Removing the outdoor fan motor
(1) Remove the cabinet. (Refer to 1)
(2) Disconnect the connector to remove the clamp of fan motor
lead wire.
(3) Remove the propeller fan nut and remove the propeller fan.
(4) Remove screws fixing the fan motor.
4. Removing the compressor
(1) Remove the cabinet. (Refer to 1)
(2) Remove the soundproof felt.
(3) Remove the terminal cover on the compressor.
(4) Disconnect lead wires from the glass terminal of the com-
pressor.(Refer to 2)
(5) Recover gas from the refrigerant circuit.
(6) Disconnect the welded part of the discharge pipe.
(7) Disconnect the welded part of the suction pipe.
(8) Remove nuts fixing the compressor.
(9) Remove the compressor.
NOTE
Before using a burner, reclaim gas from the pipes until the
pressure gauge shows 0 kg/cm
Use the burner under the condition that gas can be recovered
even when the inner pressure rises by heat.
2 (0MPa).
Photo 4
Propeller fan
Photo 5
Glass
terminal
Discharge
pipe
42
PHOTOS
Clamp Connector
Propeller fan nut
Compressor set nuts
Suction
pipe