Table of Contents
Advertisement
Installing the expansion unit in a
NetBAY enclosure
NetBAY enclosures are stackable and each can store a
different device, such as the EXP200 expansion unit. You
can also attach a server on top of the enclosure. Refer to
the NetBAY documentation for details on installing other
devices.
Note: Due to the depth of the NetBAY3E enclosure, it
might be difficult to set the expansion unit option
switches once installed. Verify that Option Switch
5 is set to Off and Option Switch 1 and the tray ID
switch are set properly for your environment (see
"Setting the interface options" on page 48 for
further device setting s ).
To install the expansion unit in the enclosure, use the
following procedure:
1. Remove the rear of the enclosure 1 .
2. Use the following illustration to determine the
appropriate enclosure mounting holes for installing
cage nuts to secure your device and rails.
Front
3. On the rail marked "L", remove and save the small
screw 2 ; then, loosen the four large screws 3 .
Netfinity EXP200 Type 3530
Rear
55
Advertisement
Chapters
Table of Contents
