IBM EXP15 Hardware Maintenance Manual page 64

4. Hold the rail against the outside of the left enclosure
mounting flange and loosely insert the front black hex
screws 4 .
5. Extend the rail outside of the rear enclosure mounting
flange; then, install and tighten both rear black hex
screws 5 .
6. Tighten the two front screws 4 ; then, tighten the
four large screws 3 .
Repeat step 3 on page 55 through step 6 to install
the rail marked "R" on the right side of the enclosure.
7. Slide the expansion unit into the enclosure; then,
remove and discard both white screws and wingnuts
6 from the bezel.
8. Align the bezel locator pins with the expansion unit;
then, secure the bezel and EXP200 with two black
hex screws 7 .
9. Use the two small screws 2 (removed in step 3 on
page 55) to secure the rear of the expansion unit.
10. Install hard drives, fans, and power supplies in the
EXP200 expansion unit.
56
IBM Netfinity EXP15, EXP200, EXP500 HMM