Table of Contents
Advertisement
assembly; then slide the front rail assembly forward
3 until it makes contact with the front rack rail.
Note
Make sure the front rail position matches the rear
rail position.
3. From the front of the rack, thread one (black) hex
head screw 4 into the bottom position of the rail
assembly and tighten firmly.
Note
Before tightening, make sure the pins are located
correctly in the rail holes.
4. Firmly tighten the screws on the rear of the rack and
the four interior screws on the rail assembly.
5. Repeat the rail assembly procedure on the opposite
side of the rack.
6. Remove the two small 6-32 screws 1 on the interior
side of the rails. Save these screws to install the
expansion unit
Netfinity EXP15 Type 3520
Rear of Rack
21
Advertisement
Chapters
Table of Contents
