Installing The Expansion Unit In A Tower Conversion Kit - IBM EXP15 Hardware Maintenance Manual

Installing the expansion unit in a tower
conversion kit
The EXP200 Rack-to-Tower Conversion Kit provides an
enclosure for a single EXP200 expansion unit. Use the
mounting hardware that comes with the EXP200 expansion
unit to install the unit in the enclosure as follows:
1. Unlock and open the enclosure door.
2. Turn the EXP200 expansion unit counter-clockwise
onto its left side and slide it into the enclosure; then,
remove the white screws and wingnuts from the
EXP200 bezel.
3. Align the bezel locator pins with the expansion unit;
then, secure the bezel and EXP200 with black hex
screws 1 on the top and bottom.
4. Remove the two small screws from the rails that
come with the EXP200 expansion unit; then, secure
the rear of the expansion unit with the small screws
2 on the top and bottom.
5. Verify that Option Switch 5 is set to On (see "Setting
the interface options" on page 48 for further device
settings).
6. Install hard drives, fans, and power supplies in the
EXP200 expansion unit.
54
IBM Netfinity EXP15, EXP200, EXP500 HMM