Settings On The Hbs 321-2 And 361-2 - Holzstar HBS 231-1 Instruction Manual

Step 3: Use the turning handle to set the upper saw band rol-
ler in the lowest position and then relax saw band.
Handle
Fig. 45: Set the lowest position
Step 4: Remove the old saw blade.
Step 5: Insert a new saw band with the correct direction.
Step 6: Retighten the twist grip and tighten the saw blade as
described in chapter 8.2.
Step 7: Close the upper and lower roller cover.
Step 8: Re-attach the guide rail to the band saw.
Step 9: Align the saw blade. Switch on the bandsaw and
make sure that the saw blade is moving correctly.

8.3 Settings on the HBS 321-2 and 361-2

DANGER!
- Before any adjustment, set-up and maintenance
work on the machine, the machine must be swit-
ched off and the mains plug must be disconnected!
Adjusting the tilting table
Step 1: Release the latch with the quick release lever.
Step 2: Pivot the table until the desired angle is reached.
Step 3: Fix the table and check the angle markings with
the aid of the scale display.
Step 4: Perform a trial cut to control the angle.
HBS Series | Version 1.02
handle
Fig. 46: Setting the swivel table
Aligning the saw blade
If the saw blade does not run in the middle of the rollers,
the tracking must be corrected by adjusting the inclina-
tion of the band saw blade.
Step 1: Open the top and bottom roller cover.
Roller cover
Fig. 47: Roller cover
Step 2: Slowly turn the top roller clockwise by hand. The
saw band should run centrally on the rubber pads
of the roller. Be careful not to grab the saw blade.
Step 3: If the saw blade does not run in the middle, correct
the saw blade by turning the dial to the left or right.
handle
Fig. 48: Rotary knob for tilt adjustment
Step 4: Check the run of the saw blade on the roller. It
should rest in its full width on the rubber pad.
Step 5: After completing the adjustments, fix everything
again and close both covers.
Seetings
swivel table
Rotary knob
21