Seetings On The Hbs 261-2 - Holzstar HBS 231-1 Instruction Manual

A saw blade change is required when using different ma-
terials and material thicknesses, as well as worn saw
band.
Step 1: Lower the upper saw blade guide to the lowest
position and unscrew the lock nut, washers and
wing screws on the saw table.
Fig. 28: Change saw blade
Step 2: Open the upper and lower roller cover.
roller cover
Fig. 29: Open the roller cover
Step 3: Open the saw blade cover.
Saw blade cover
Fig. 30: Open the saw blade cover
Step 4: Loosen the saw blade with the quick release
lever.
HBS Series | Version 1.02
Screw
Fig. 31: Loosen the saw blade
Step 5: Remove the old saw blade.
Step 6: Insert a new saw blade in the correct direction.
Step 7: Tighten the tension lever again and tighten the saw
blade as described in chapter 8.1.
Step 8: Screw the nut, washers and wing screws to the saw
table.
Step 9: Close the upper and lower roller cover and the saw
blade cover.
Step 10: Align the saw blade. Switch on the bandsaw and
make sure that the saw blade is moving correctly.

8.2 Seetings on the HBS 261-2

DANGER!
- Before any adjustment, set-up and maintenance
work on the machine, the machine must be swit-
ched off and the mains plug must be disconnected!
Adjusting the tilting table
Step 1: Release the latch with the quick release lever.
Step 2: Swing the table with the angle adjustment knob
until the desired angle is reached.
Step 3: Fix the table and check the angle marks with the
scale display.
Step 4: Perform a trial cut to control the angle.
Seetings
Handle
17