Seetings
Speed
Bottom engine pulley
Engine pulley
Fig. 40: Set cutting speed
Step 4: Close the lower roller cover.
Adjusting the belt tension
NOTE!
If necessary, adjust the motor position to adjust the
belt tension.
Step 1: Release the lock of the motor and turn the motor
counterclockwise to reduce the tension of the
drive belt. Turn the motor clockwise to increase
the tension of the drive belt.
Screw for engine
Fig. 41: Adjust belt tension
Step 2: Position the motor so that the drive belt in the
middle can be pressed through approx. 10mm.
Then fix the engine again and close the lower
roller cover.
Engine pulley
Driving belt
Fig. 42: Belt tension
20
Belt pulley
Changing the saw band
DANGER!
Before changing the saw blade, switch off the ma-
chine, pull out the mains plug and wait until the band
saw band stops.
Wearing safety gloves!
DANGER!
Use only suitable saw bands!
DANGER!
Make sure to insert the new saw blade correctly!
Make a note of which direction the teeth of the old saw
band are pointing!
A saw blade change is required when using different ma-
terials and material thicknesses, as well as worn saw
band.
Step 1: Detach the guide rail and remove it from the
band saw.
Handle guide rail
Fig. 43: Remove guide rail
Step 2: Open the upper and lower roller cover.
roller cover
Fig. 44: Open the roller cover
HBS Series | Version 1.02