Table of Contents
Advertisement
8.3 Control System Introduction
The NuAire Incubator Control Electronics system is designed to serve the control requirements of the Incubator chamber.
Temperature and CO
chamber. Operator input is coordinated through the NU-TOUCH LCD keypad and status displays.
Figure 1 shows the various inputs and outputs of the system.
The NuAire Incubator Control Electronics is a state-of-the-art microcomputer-based system that provides:
8.3.1 Chamber control in a single electronic package.
8.3.2 Enhanced information presentation on a Nu-Touch LCD
Main Screen Continuously displays:
•
Measured Chamber Temperature
Measured CO
•
•
Current Screen ID "MAIN SCREEN"
•
A mode status indicator (RUN, STANDBY or Power Loss Recovery)
NuAire Logo button Leads to the System settings
•
(Or Password) menu when pressed
•
Date and Time
•
Air, CO
•
An Alarm Status Menu
8.3.3 Active buttons on the MAIN SCREEN:
OM0245
Rev 6 March/2022
levels are controlled by preset values to provide the optimum conditions for culture growth within a
2
level in the chamber
2
inject, door ajar status displays.
2
Button Description
Control system description
i.e.TEMP or CO2)
Measured value of each control system
NuAire Logo
Date & time display
Action when touched
Brings a pop-up screen that describes the
control system that was touched
Goes to the Environmental Set Point Screen
(Keypad to enter the password will pop up if the
password function is enabled)
Goes to "System Settings" Screen
Goes to screen for adjusting time and date
Page 18 of 53
Advertisement
Table of Contents
