Figure 36
1. Spring loaded idler pulley
2. Short hook end
7. Pull back on the spring loaded idler pulley and install
the belt onto the spring loaded idler pulley
Checking and Adjusting the
Blower Latch
Close the blower assembly to see if the latches are adjusted
correctly. Loosen or tighten the bolts so the latches firmly
hold the blower assembly against the mower deck , but can be
released by hand.
Figure 37
1. Latch
2. Bolt
Greasing the Idler Arm and
Handle Pivot
Service Interval: Every 50 hours—Grease the idler arm.
Every 100 hours—Grease the handle pivot.
3. Long hook end
(Figure
35).
3. Blower assembly
Grease the blower belt idler arm
Grease the handle pivot
23
(Figure
38).
Figure 38
(Figure
39).
Figure 39