Pro-Form momentum L4.8 User Manual page 8

7. Identify the Left Handlebar (6), which is marked
with a "Left" sticker.
Insert the Left Handlebar (6) into a Handlebar
Arm (5). Make sure that the hexagonal holes
are on the indicated side.
Attach the Left Handlebar (6) with two M6 x
38mm Button Bolts (50) and two M6 Locknuts
(27). Make sure that the Locknuts are inside
the hexagonal holes. Do not tighten the
Button Bolts yet.
Apply a small amount of the included grease to
the left axle on the Upright (2).
Slide a Handlebar Spacer (47) and the Left
Handlebar (6) onto the left axle on the Upright
(2). Make sure that the curved side of the
Handlebar Spacer is facing the Upright. Then,
tap an Axle Cap (14) onto the axle.
Repeat this step for the Right Handlebar (8)
and the other Handlebar Arm (5).
8. Apply a small amount of grease to the axle on
the left Disc Crossbar (16). Slide the Left Pedal
Arm (11) onto the axle, and then place a Wave
Washer (64) on the axle. Next, tighten an M10 x
25mm Patch Screw (22) and an M10 Washer
(35) into the axle.
Apply a small amount of grease to a Pedal Arm
Bolt Set (40). Next, hold the left Handlebar Arm
(5) inside the bracket on the Left Pedal Arm
(11). Attach the Left Pedal Arm to the left
Handlebar Arm with the Bolt Set. Do not over-
tighten the Bolt Set; the Handlebar Arm
must pivot freely.
Attach the Right Pedal Arm (not shown) in
the same way.
See step 5. Tighten the M10 x 68mm Button
Bolts (48).
See step 7. Tighten the M6 x 38mm Button
Bolts (50) in the Handlebar Arms (5).
9. Make sure that all parts of the elliptical exerciser are properly tightened. Note: Some hardware may be
left over after assembly is completed. To protect the floor or carpet from damage, place a mat under the
elliptical exerciser.
All manuals and user guides at all-guides.com
8
7
6
Grease
14
50
Hexagonal
5
8
5
40
Grease
11
40
8
2
5
47
27
Holes
16
Grease
64
22 35