Table of Contents
Advertisement
ASSEMBLY
To hire an authorized service technician to assemble the elliptical exerciser, call 1-800-445-2480.
Assembly requires two persons. Place all parts of the elliptical exerciser in a cleared area and remove the
packing materials. Do not dispose of the packing materials until assembly is completed.
In addition to the included tool(s), assembly requires a Phillips screwdriver
wrench
, and a rubber mallet
See the drawings below to identify the small parts needed for assembly. The number in parentheses below each
drawing is the key number of the part, from the PART LIST near the end of this manual. The number following
the key number is the quantity needed for assembly. Note: Some small parts may have been preassembled.
If a part is not in the hardware kit, check to see if it has been preassembled.
M6 Locknut
(27)–4
M6 x 18mm
Screw (43)–4
M10 x 68mm Button Bolt (48)–2
All manuals and user guides at all-guides.com
M10 Locknut
M10 Split
(33)–6
Washer (59)–2
M6 x 38mm
Button Bolt (50)–4
Pedal Arm Bolt Set (40)–2
.
Wave Washer
(64)–2
M6 x 45mm Flat Head
Screw (36)–4
M10 x 75mm Carriage Bolt (34)–4
5
, an adjustable
M10
Washer (35)–2
M10 x 25mm
Patch Screw (22)–2
Advertisement
Table of Contents
