Table of Contents
Advertisement
Figure4-3 Removing an interface module
1
Replacing a drive
CAUTION:
• To avoid storage medium damage, execute the
partitions before removing a drive.
• Do not hot swap drives.
To replace a drive:
1.
Log in to the Web interface. Click the Unmount button on the Storage settings page.
2.
Wear an ESD wrist strap and make sure it makes good skin contact and is reliably grounded.
3.
Press the button at the right side of the drive panel to release the locking lever.
4.
Hold the locking lever and pull the drive out of the slot.
5.
Install a new drive. For the installation procedure, see
Figure4-4 Removing a drive
Replacing a transceiver module
WARNING!
Disconnected optical fibers or transceiver modules might emit invisible laser light. Do not stare into
beams or view directly with optical instruments when the firewall is operating.
When you replace a transceiver module, make sure the two transceiver modules connected by the
same optical fiber are the same type. Do not touch the golden plating of the transceiver module.
1
2
1
3
2
2
command from the CLI to unmount all
umount
"Installing a
4-32
drive."
3
Advertisement
Table of Contents
Need help?
Do you have a question about the SecPath F10X0 and is the answer not in the manual?
Questions and answers