Valor PORTRAIT 530IN Installation Manual page 29

Installation
Top row rear
TL
TFL
ML
L
BL
Bottom row front
Install rocks
To get the optimal flame effect,
it is important to place the
rocks in their appropriate
position. Each rock is
embossed underneath with
letters and an arrow indicating
the position of the rock. The
arrows point to the front of the fireplace when the
rock is installed. See the image and table at the top of
the page to help you with the identification and position
of the rocks.
1. Identify the rocks TFL, TL, TR, and TFR. These rocks
have pegs that fi t in the holes on the top of the rock
base. Install these rocks positioning them so that
the arrow embossed underneath point to the front
of the fi replace.
2. Identify the rocks BL, BC, and BR. These rocks have
two holes that fi t on the pegs of the ceramic plat-
form. Install these rocks positioning them so that
the arrow embossed underneath point to the front
of the fi replace.
TFL
TR
TFR
MC MR
BC BR
Middle row
The edge of the
platform is visible
under the rock
Rock
Description
ID
TFL Top far left
TL Top left
TR Top right
TRF Top far right
R
BL Bottom left
BC Bottom center
BR Bottom right
ML Middle left
MC Middle center
MR Middle right
L Left
R Right
3. Identify the rocks ML, MC, and MR. Those rocks
have pegs that fi ts in the holes on the top of the
rocks on the front row. Install those rocks position-
ing them so that the arrows underneath point to the
front of the fi replace.
4. Identify the rocks L and R. Those rocks don't have
any peg or hole. Install those rocks as indicated, at
the left and right of the rock pile positioning them
so that the arrows underneath point to the front of
the fi replace. The rock rests against the other rocks
and is at an angled position. Make sure that the TFL
rock at the rear left is in the proper angle—see image
L rock
Fuel Beds
Other Position in the
markers fi rebox
1 peg under Top row rear
1 peg under Top row rear
1 peg under Top row rear
1 peg under Top row rear
2 holes under, 1
Bottom row front
peg above
2 holes under, 1
Bottom row front
hole above
2 holes under, 1
Bottom row front
peg above
1 hole under Middle row
1 peg under Middle row
1 hole under Middle row
— Left side
— Right side
This rock is held by
a peg and does not
touch the rocks of
the back row
in step 2. See the image
at the top of the page.
You must be able to see
the edge of the platform
under the L rock as indi-
cated at left.
29