Table Of Contents - Furuno RD-30 Operator's Manual

TABLE OF CONTENTS

FOREWORD ........................................... iii
SYSTEM CONFIGURATION ................... iv
1. OPERATION .....................................1-1
1.1 Controls............................................ 1-1
1.2 Turning On/Off the Power ................ 1-2
1.3 Adjusting Key Panel Dimmer,
Display Contrast ............................... 1-2
1.4 Selecting a Display .......................... 1-3
1.4.1 Sample displays .................... 1-4
1.5 Setting up the Displays .................... 1-8
1.5.1 Choosing display type ........... 1-8
1.5.2 Setting up digital displays ..... 1-9
1.5.3 Setting up graph displays.... 1-10
1.5.4 Setting up graphic displays . 1-13
1.6 Displaying Rx Data ........................ 1-14
1.7 Alarms ............................................ 1-15
1.7.1 Audio alarm type ................. 1-15
1.7.2 Speed alarm ........................ 1-16
1.7.3 Water temperature alarm .... 1-16
1.7.4 Depth alarm......................... 1-17
1.7.5 Arrival alarm, anchor watch
alarm ................................... 1-18
1.7.6 XTE (Cross Track Error)
alarm ................................... 1-19
1.7.7 Trip alarm ............................ 1-19
1.7.8 Odometer alarm .................. 1-20
1.7.9 Time alarm .......................... 1-20
1.7.10 Countdown alarm ................ 1-20
1.7.11 Alarm messages ................. 1-21
1.8 Resetting Indications to Zero ......... 1-22
1.9 Choosing Units of Measurement ... 1-23
1.10 Applying an Offset to Data ............. 1-24
1.11 Choosing Time Display Format...... 1-25
1.12 Choosing Position Data Format..... 1-26
1.13 Simulation Mode ............................ 1-27
1.14 I/O Port Setup ................................ 1-27
1.15 Bearing Reference ......................... 1-28
1.16 Magnetic Variation.......................... 1-29
1.17 Heading Sensor PG-1000, C-2000
Setup............................................... 1-30
2. MAINTENANCE,
TROUBLESHOOTING ...................... 2-1
2.1 Maintenance..................................... 2-1
2.2 Error Messages................................ 2-1
2.3 Diagnostic Test................................. 2-2
2.4 When BATTERY ALARM! Appears.. 2-3
2.5 Clearing Backup Data ...................... 2-4
MENU TREE ........................................ M-1
LORAN C/ A CHAINS.......................... M-3
DECCA CHAINS.................................. M-4
SPECIFICATIONS ..............................SP-1
INDEX ............................................ Index-1
ii