Choosing Units Of Measurement - Furuno RD-30 Operator's Manual

1.9

Choosing Units of Measurement

You may choose the units of measurement for water temperature,
distance/speed, depth and wind speed as follows:
1. Press the [MENU] key once or twice to display the main menu.
2. Select UNITS and then press the [ENT] key.
3. Select TEMP, DIST/SPD, DEPTH or WIND SPD and WIND (wind speed
averaging and wind direction reference) as appropriate and then press the
[ENT] key. One of the following displays appears depending on the selection
you made.
C
°
F
°
XX.XX
XX.X
Temperature
unit options
4. Use the cursor pad to select unit desired and then press the [ENT] key. For
items other than WIND, go to step 5. For WIND, do the following:
a) Choose an averaging time and then press the [ENT] key. Wind speed is
averaged every two seconds during the period chosen. This setting also is
effective for the graph and graphic displays and the wind speed shown by
pressing the [*] key.
b) Press the [ENT] key again.
c) Choose TRUE or APPARENT and then press the [ENT] key.
TRUE: The speed and direction of the wind felt or measured when stationary.
APPARENT: The direction and speed of the wind as it appears to those on
board, relative to the speed and direction of the boat; combination of the true
wind and the wind caused by the boat's movement.
5. Press the [MENU] key twice to close the menu.
TEMP
DIST/SPD : NM, KT
DEPTH
WIND SPD: KT
WIND
NM, KT
KM, KM/H
SM, MPH
Distance/speed
unit options
Depth unit
options
UNITS SETUP
°
: F XX.XX
: FT
: OFF TRUE
Units setup menu
M KT
FT KM/H
FA MPH
PB M/S
Wind speed
unit options
Unit options
1. OPERATION
OFF
1MIN
TRUE
5MIN
APP
10MIN
Wind averaging, wind
direction reference options
1-23