Dimensions & Cavity - Valor Portrait 530INI Installation Manual

Dimensions & Cavity
Dimensions
Varies with front trim.
See Front trims installation
manuals for dimensions.
Ensure base of
hearth height,
otherwise
546 Ledgeview front,
4-sided frame drops
1-1/2" below
heater bottom.
530 insert engine with standard
co-linear vent (as supplied)
Cavity
X
8
9" - 11-1/2"
depending on
front trim - see front
installation manual
2 x 3" dia.
colinear vent
(as supplied)
Check that masonry step does not interfere with install dimensions
or vent pipe.
If mantel is combustible, see the following section for allowable
clearances.
Minimum Cavity Dimensions
Depth (X)
Y
Height (Y)
Width (not shown)
20"
Ensure base of heater is flush*
with finished hearth height,
otherwise front will not fit.
*Note: If installing 546 Ledgeview
front, 4-sided frame drops 1-1/2"
below heater bottom.
9–11-1/2" [229–292 mm]—varies with front trim options
25-1/2" [648 mm]—Note: using 546 Ledgeview front
requires additional 1-1/2" [38 mm]
20-1/2" [521 mm]
Attention
See below for minimum
cavity dimensions!
Varies with front trim.
See Front trims installation
manuals for dimensions.
5"x 3" dia.
co-axial adaptor
530 insert engine with optional
530CVA2 co-axial appliance adapter