Other Settings; Resetting Watch Settings - Casio 5672 Operation Manual

4.
If the 24-hour hand is at the 12 position
(straight downwards), hold down (B) for at
least two seconds to move it to the 24
position (straight upwards).
5.
Press (C).
Confirm that the small hour and minute
hands, and the small 24-hour hand are all
stopped at 12 o'clock.
Small 24-hour hand
Small minute hand
Small hour hand
6.
If the small hour and minute hands, and
the small 24-hour hand are not at 12
o'clock, rotate the crown to align them with
12 o'clock.
7.
Press (C).
Confirm that the mode hand is stopped at
12 o'clock, and check if the day is
indicated properly.
Mode hand
Day (Operation start day)
8.
If the mode hand and/or the day indicator
is out of alignment, rotate the crown to
move the mode hand to 12 o'clock and the
day to the center of the indicator window.
The movement range of the mode hand
●
and day indicator is limited when you
rotate the crown. The maximum left-
right movement of the mode hand is 180
degrees in either direction. The day
indicator moves only slightly.
After the mode hand and day indicator
●
are in the positions you want, advance
to step 11 of this procedure. If you are
unable to make the adjustments you
want, go to step 9.
Watch Operation Guide 5672
9.
Press (C).
Confirm that the day indicator shows "1".
The mode hand will rotate repeatedly
●
while the date setting is being adjusted.
In some cases, the mode hand may
continue to rotate for about 20 minutes.
Hand and Day Indicator Movement
l
10.
If "1" is not shown for the day, rotate the
crown until "1" is shown for the day.
The mode hand moves in conjunction
●
with crown rotation. Move the mode
hand to 12 o'clock.
11.
Push the crown back in and then lock it.
Note
Leaving the crown pulled out for more
●
than approximately 30 minutes without
performing any operation will
automatically cause the adjustment
operation to become disabled. If this
happens, push the crown back in to its
normal position and then pull it out
again to restart the procedure from the
beginning. Pushing the crown in to its
normal position part way through the
alignment procedure will cause the
hands to return to their normal position.
Any alignment you performed up to
that point will be applied.
This section explains other watch settings you
can configure.

Resetting Watch Settings

This section explains how to return the watch
settings below to their initial factory defaults.
Day
Watch Settings
●
Stopwatch
●
Timer
●
Alarm
●
1.
2.
3.
4.

Other Settings

Enter the Timekeeping Mode.
Navigating Between Modes
l
Loosen the crown and then pull it out to the
second click.
Hold down (C) for at least five seconds
until the second hand points to 12 o'clock
twice.
Second hand
Push the crown back in and then lock it.
Crown
26