Subscribe to Our Youtube Channel
Related Manuals for Casio 5672
Summary of Contents for Casio 5672
-
Page 1: Table Of Contents
Contents Time Adjustment Adjusting Hand and Day Indicator Alignment Time Adjustment Using a Time Signal Precautions Using CASIO WATCHES to Adjust Hand and Overview Day Indicator Alignment Appropriate Signal Reception Location Operating Precautions Adjusting Hand and Day Indicator Alignment Time Calibration Signal Reception... -
Page 2: Precautions
Do not operate the crown or buttons while ー retailer or to an authorized CASIO service Example of Daily Use your watch is submersed in water or wet. center. Hand washing, rain Avoid wearing your watch while in the ー ... - Page 3 Note that CASIO Computer Co., Ltd. assumes no responsibility for any damage or loss suffered by you or any third party arising through the use of your...
-
Page 4: User Maintenance
CASIO service by charging is too short, contact your and a mild neutral detergent, or with soapy center. -
Page 5: Mobile Link Precautions
When in a hospital, on an aircraft, or in any criminal offense. For details, visit the CASIO other area where the use of radio waves is not Website. -
Page 6: Before Getting Started
Watch Operation Guide 5672 General Guide Watch Face Items Before Getting Started... ① ② ③ ③ ① This section provides an overview of the watch ④ and introduces convenient ways it can be ⑤ used. ④ ⑩ ② Watch Features ⑥... -
Page 7: Navigating Between Modes
Watch Operation Guide 5672 Navigating Between Modes Mode Overview Last signal receive result/auto time G adjustment setting status Timekeeping Mode Each press of (C) cycles between watch ● The second hand points to [Y(YES)] or modes. The main hour, minute, and second hands indicate the current time. -
Page 8: Using The Crown
Watch Operation Guide 5672 Stopwatch Mode Alarm Mode ● ● Using the Crown The second hand, and the small hour and The small hour and minute hands indicate the minute hands indicate the elapsed stopwatch alarm time. The watch’s crown is a screw-in (screw lock) time. -
Page 9: Hand And Day Indicator Movement
Watch Operation Guide 5672 Checking the Charge Level ● Hand and Day Indicator Charging Pressing (A) causes the mode hand to Movement indicate the current charge level. To return the This watch runs on power supplied from a mode hand to its original position (current day... -
Page 10: Viewing The Face In The Dark
Watch Operation Guide 5672 Dead Battery Power Saving ● Viewing the Face in the Dark All hands and the day indicator are stopped. Leaving the watch in a dark location for about one hour between the hours of 10 p.m. and The watch has an LED light that you can turn 5:50 a.m. -
Page 11: Useful Features
Install the required app on your ● phone. In Google Play or the App Store, search for the CASIO “CASIO WATCHES” app and install it on your phone. Note In addition, a number of other watch settings can be configured using your phone. -
Page 12: Auto Time Adjustment
The watch will connect with a phone at preset connection between the watch and a phone. times each day and adjust its time settings. Specifying a World Time City with CASIO Whenever you want to trigger immediate time WATCHES causes the watch’s World Time Using This Function ●... - Page 13 Watch Operation Guide 5672 Selecting a World Time City Configuring the Summer Time Setting Swapping Your World Time and Home ● ● ● Time 1. Y 1. Y Tap the “CASIO WATCHES” icon. Tap the “CASIO WATCHES” icon. 1. Y Tap the “CASIO WATCHES”...
-
Page 14: Setting The Alarm
Important! Configuring Watch Settings Phone finder will not sound the tone ● You can use CASIO WATCHES to specify the unless CASIO WATCHES is running amount of time until the Bluetooth connection on the phone. is automatically terminated, and to configure Do not use this function in areas where ●... -
Page 15: Changing The Home City Summer Time Setting
1. Y Tap the “CASIO WATCHES” icon. CASIO WATCHES app is not running calibration signal receive or connection with a on your phone. On your phone’s home 2. X Hold down (C) for at least 2.5 seconds... -
Page 16: If You Purchase Another Phone
Watch Operation Guide 5672 Deleting Pairing Information from the Referring to the information below, configure ● Time Adjustment Watch the time setting in accordance with the method that suits your own lifestyle. 1. X Hold down (C) for at least one second... -
Page 17: Time Adjustment Using A Time Signal
Watch Operation Guide 5672 Time Adjustment Using a Appropriate Signal Reception Time Calibration Signal Reception Time Signal Location Ranges A time calibration signal can be received while Japan (JJY) ● Overview the watch is near a window. The Japan time signal radio stations are Position the watch so its 12 o’clock side is... -
Page 18: Auto Time Calibration Signal Receive
If your watch is connected with a phone, ● settings must be configured so CASIO WATCHES can acquire location information. Even if you are in an area that is within the reception range of a time signal,... -
Page 19: Using Watch Operations To Adjust The Time Setting
Watch Operation Guide 5672 Adjusting the Time and Day Setting ● Using Watch Operations to Press (C). Adjust the Time Setting Loosen the crown and then pull it out to the This enables the month setting operation. second click. If your watch cannot connect with a phone for Rotate the crown to change the month. -
Page 20: Checking The Last Time Adjustment Result
Push the crown back in and then lock it. Note If the watch is paired with a phone, ● CASIO WATCHES can be used to Push the crown back in and then lock it. disable auto time adjustment. Using CASIO WATCHES to... -
Page 21: Dual Time
City (Time Zone) Table If the watch is paired with a phone, you can and standard time. also use CASIO WATCHES to set the World For information about areas where New York (-5 offset) Time city. -
Page 22: Swapping The Home City Time And Dual Time
If the watch is paired with a phone, you can from the Alarm Mode to the Home City time with your Dual Time by holding also use CASIO WATCHES to set alarms. Timekeeping Mode if you do not down (B) for at least three seconds. -
Page 23: Turning Off An Alarm
Watch Operation Guide 5672 After Arriving ● Turning Off an Alarm Moving to Another Time Zone Swap the origin time zone time with the To stop the alarm from sounding, perform the destination time zone time. steps below to turn it off. -
Page 24: Stopwatch
Using CASIO WATCHES to Seconds indicated for about five seconds. Configure Timer Settings Start If the watch is paired with a phone, you can also use CASIO WATCHES to set the timer Split start time. Configuring Watch Settings Stop Hours... -
Page 25: Setting The Countdown Start Time
(D). Seconds Press any button to stop the tone. If the watch is paired with a phone, you can also use CASIO WATCHES to adjust hand and day indicator positions. Adjusting Hand and Day Indicator Alignment... -
Page 26: Other Settings
Watch Operation Guide 5672 Other Settings If the 24-hour hand is at the 12 position Press (C). (straight downwards), hold down (B) for at Confirm that the day indicator shows “1”. least two seconds to move it to the 24 This section explains other watch settings you position (straight upwards). -
Page 27: Other Information
City (Time Zone) Table Hour, minute, second, day (2000 to 2099 full auto calendar), day of the week For information about phones that can Second connect with the watch, visit the CASIO Time Representative Receivable Signal Receive Functions : Hand website. -
Page 28: Copyrights And Registered Copyrights
● Bluetooth SIG, Inc. and any use of such When the crown is pulled out ● marks by CASIO Computer Co., Ltd. is While the watch is paired with a phone ● under license. For information about unpairing, see iPhone and App Store are trademarks of ●... - Page 29 “Adjusting Hand and The second hand will point to [C] once Day Indicator Alignment” to auto adjust ● Did you install CASIO WATCHES on your after about 0.5 seconds, and then a hour and minute hand alignment. phone? second time after about 2.5 seconds.
- Page 30 Phone Model Connection with the watch is not possible Turn on the phone and then tap the “CASIO while your phone is in the Airplane Mode. After WATCHES” icon. Next, on the watch, hold Connecting the current watch to exiting the phone’s Airplane Mode, go to the...
- Page 31 Watch Operation Guide 5672 Hand Movement and Time is not displayed correctly. Hands are stopped and buttons do not work. Indications If your phone is unable to receive a signal because you are outside its service range or The watch is in the charge recovery mode.
- Page 32 Watch Operation Guide 5672 Crown Operations Nothing happens when I rotate the crown. If you do not perform any operation for about two minutes after pulling out the crown (approximately 30 minutes in the case of hand and day indicator alignment), crown operations will automatically become disabled.
Need help?
Do you have a question about the 5672 and is the answer not in the manual?
Questions and answers