Using The Timer; Other Settings; Enabling The Button Operation Tone; Configuring Power Saving Function Settings - Casio 3545 Operation Manual

Using the Timer

The timer counts down time in 1-second units.
1.
Enter the Timer Mode.
Navigating Between Modes
l
Hour, minute, second
2.
Use the operations below to perform a
timer operation.
D
Start
(Countdown starts)
D
Pause
D
Resume
(Time up)
A beeper will sound for 10 seconds to
●
let you know when the end of a
countdown is reached.
You can reset a paused countdown to
●
its start time, by pressing (A).
3.
Press any button to stop the tone.
Watch Operation Guide 3545

Other Settings

This section explains other watch settings you
can configure.
Enabling the Button
Operation Tone
Use the procedure below to enable or disable
the tone that sounds when you press a button.
1.
Enter the Timekeeping Mode.
Navigating Between Modes
l
2.
Hold down (A) for at least two seconds.
Release the button when the city code
starts to flash.
3.
Press (C) nine times.
This causes [KEY♪] or [MUTE] to flash on
the display.
4.
Press (D) to select [KEY♪] or [MUTE].
[KEY♪]: Operation tone enabled.
[MUTE]: Operation tone disabled.
5.
Press (A) to complete the setting
operation.
[
●
tone is muted.
City code
] is displayed while the operation
Note
While the setting is being configured,
●
the watch will exit the setting operation
automatically after about two or three
minutes of non-operation.
Note that alarm and timer tones will still
●
sound even while the operation tone is
muted.
Configuring Power Saving
Function Settings
1.
Enter the Timekeeping Mode.
Navigating Between Modes
l
2.
Hold down (A) for at least two seconds.
Release the button when the city code
starts to flash.
City code
3.
Press (C) 11 times.
This displays [PS].
4.
Press (D) to toggle between on and off.
[On]: Power Saving enabled.
[OFF]: Power Saving disabled.
5.
Press (A) to complete the setting
operation.
Note
While the setting is being configured,
●
the watch will exit the setting operation
automatically after about two or three
minutes of non-operation.
For details about Power Saving, refer
●
to the information below.
Power Saving Function
l
14